6) Removing the Workpiece
(1) Turn Rack Handle clockwise and return Spindle Case.
(2) Loosen Vise and pull out the workpiece.
7) Cleaning after Use
Remove chips scattered on the machine or in the area.
Use a wire brush and clean and remove chips from Dies of Die-Head and Vise-Jaw.
Use waste cloth and wipe off the threading oil splashed over the machine and the area.
5. MAINTENANCE & INSPECTION
1) Replacement of Parts
1-1)
Replacement of Switch
(1) Remove the four screws, and pull out Switch Plate on the front.
(2) Remove the four lead wires from the switch.
(3) Remove the switch from Switch Plate.
(4) Install a new switch on Switch Plate.
(5) Install the four lead wires to the switch.
(6) Install Switch Plate into the machine with the four screws.
Switch Plate
• The workpiece is wet and slippery with threading oil. Use utmost care not
to drop on your feet.
17
• Disconnect Power Plug to avoid electric shock.
〈
14
〉
Switch
Screw
• Do not blow off chips using air. They may get into eyes and loss of
eyesight may result.
• Chips are sharp. Do not touch them with bare hand. Always wear gloves.
