PIPE SAW 200SP
18
TROUBLESHOOTING
Phenomenon
Cause
Measures
Power Issue /
Machine not
working
Damaged Power Cord
Replace the power cord if damages are
found.
Low voltage
When the extension cord is too long or
too thin, see "Extension Cord" on P9
and use a proper extension cord.
Working Over-load
Protector
Make sure that the motor is cooled
down enough, and then turn on the
switch again.
Insufficient
power
Low voltage
When the extension cord is too long or
too thin, see "Extension Cord" on P9
and use a proper extension cord.
The Saw Blade
is broken, and/
or is loose
Loosed Clamp Bolt of
Blade Holder
Re-tighten Clamp Bolt.
Forcing the machine to cut Do not cut by force. Cut slower.
Unfixed Chain Vise
Fix the Chain Vise to the work piece
firmly.
The machine
stops during
cutting
Low voltage
When the extension cord is too long or
too thin, see "Extension Cord" on P9
and use a proper extension cord.
Working Over-load
Protector
Make sure that the motor is cooled
down enough, and then turn on the
switch again. Do not cut by force. Cut
slower.
Worn out Carbon Brushes
If Carbon Brushes are worn down to
around 6mm, they must be changed.
Worn out saw blade
If the saw blade is worn out, cannot cut
properly. Change the saw blade to new
one.
Oblique cutting
Worn out saw blade
If the saw blade is worn out, it causes
of oblique cutting. Change the saw
blade to new one when it's worn out.
Jammed contaminations
between Chain Vise and
the work piece
Remove the contamination jammed
between Chain Vise and the work
piece.
Forcing the machine to cut Do not cut by force. Cut slower.
● Before asking for repairs, check following troubleshooting.
If the problem cannot be solved, contact with the shop you purchased or our
sales office.
● Troubles due to misuse or improper applications are not covered by warranty.
TROUBLESHOOTING