PIPE SAW 200SP
10
HOW TO OPERATE THE MACHINE
① Loosen the Clamp Bolt by Allen Wrench.
● Before starting operation, always read the instructions in "SAFETY INSTRUCTIONS"
and "OPERATING INSTRUCTIONS" (pages 2 to 6).
◆ In order to prevent the accident, pull out the plug from the receptacle.
The machine will start running suddenly, it will lead to accidents or injuries.
◆ Never touch the saw blade, chips and work piece immediately after
cutting.
Immediately after cutting operation, they are hot and you can get burnt or injured.
◆ Always use the power supply indicated in the machine plate.
If the operating voltage is higher than indicated, the motor will run at abnormally
high speed, which may damage the machine.
If use the machine at over voltage indicated in the machine plate or instruction
manual, the machine may become hot, emit smoke or catch fire.
◆ Make sure that the switch is off before plugging the machine in.
Pull the Trigger Switch to turn on and release to turn off. Always make sure that the
Trigger Switch returns when you release the trigger pulled.
If you insert the plug into the receptacle, not knowing the switch is on, the machine
will start abruptly, leading to an unexpected accident.
◆ In case to use engine generator, use the engine generator which
output capacity is more than 2.8KVA with inverter control type.
If use engine generator without inverter control, the machine will be broken.
How to Set the Saw Blade
Clamp Bolt
loosen
tighten
HOW TO OPERATE
THE MACHINE
WARNING
WARNING
CAUTION