ARS Automation FlexiBowl 350, Инструкция по эксплуатации

Страница: 77 / 84

7-19
FlexiBowl - models 350 - 500 - 650 - 800
CHAPTER 7 - Maintenance
7.4 Troubleshooting
no. Problem Solution
1 The status LED (Ready/Fault) is red.
• If the FlexiBowl
®
is working, check operation
of the LED or the mechanical relay inside the
interface.
• Check the condition of the fuse inside the power
input module and replace it if necessary.
• Check that the power output voltages are correct:
• 48 Vdc - for FlexiBowl
®
350;
• 60 Vdc - for FlexiBowl
®
500, 650, 800.
note: if the problem persists, contact ARS S.r.l.
2 The FlexiBowl
®
vibrates/oscillates excessively.
• Check that the screws are tightened properly.
• If the rotating belt needs replacing, make sure
that the correct operating parameters have been
set for the type of belt (the instructions are on
the USB flash drive supplied).
note: if the problem persists, contact ARS S.r.l.
3 The status LED (Ready/Fault) is off.
• Check that the power supply is correct and
working.
• Check the condition of the fuse inside the
interface and replace it if necessary.
note: if the problem persists, contact ARS S.r.l.
4 The Flip does not work.
• Check the air pressure inside the air supply
system control panel.
• Check the condition of the pressure regulator.
• Check that the power supply is correct and
working.
• Check that the valves work properly.
• Make sure the valve relay inside the interface is
working properly.
• Check the condition of the fuse inside the
interface and replace it if necessary.
note: if the problem persists, contact ARS S.r.l.