ARS Automation FlexiBowl 350, Инструкция по эксплуатации

Страница: 51 / 84

6-5
FlexiBowl
®
- models 350 - 500 - 650 - 800
CHAPTER 6 - Controls and use
Pos. Element Description
9
SEND PARAMETERS
TO FLEXIBOWL
Used to save all of the movement parameters in the FlexiBowl
®
.
10 FAULT RESET Used to reset the FlexiBowl
®
after an error.
11 TRY SEQUENCE
Opens the pop-up window where you can try a sequence of combined
movements.
12 CMD TERMINAL Command reserved for maintenance technicians.
13
SAVE PARAMETERS
TO FILE
Used to save the movement parameters in a file.
14
LOAD PARAMETERS
FROM FILE
Used to load the movement parameters from a previously saved file.
15 COMMAND SR Returns the current status of the driver.
6.2.2.1 “sElECT BIos” pop-up window
This pop-up window can be used to set the parameters for the different models of FlexiBowl
®
and surfaces.
2
1
3
Pos. Element Description
1 SELECT TYPE FLEXIBOWL Used to select the type of FlexiBowl
®
.
2 FLEXIBOWL SURFACE Used to select the type of FlexiBowl
®
surface.
3 UPLOAD BIOS PARAMETERS Used to upload the set parameters to the FlexiBowl
®
.
CAuTIon!
If a different surface is installed to the one supplied by ARS S.r.l., the FlexiBowl
®
might not work properly.