Arroyo Instruments ComboSource 6300 Series, Руководство пользователя

Страница: 57 / 60

6300 Series ComboSource User’s Manual · Page 57
disabled output forced a shutdown of the laser output.
E-512 Power failure A power failure was detected.
E-514 Laser mode change
disabled output A change in the operating mode of the
ComboSource while the output was on shutdown
the output.
E-516 Incorrect configuration
for calibration to start
The ComboSource was not configured properly,
including the mode and output on state, to be
able to start the desired calibration process.
E-517 Calibration must have
the output on to start The laser output must be on for the calibration
process to start.
E-521 TEC temperature limit
disabled output The laser output was turned off because the TEC
temperature limit was exceeded corresponding
bit in the OUTOFF register was set.
E-534 Po mode selected with
PD Response set to
zero Attempted to select Po mode and PD Response
was zero, or ComboSource was in Po mode and
PD Response was set to zero.
E-535 Calibration cancelled The active calibration process was cancelled.
E-536 Intermittent contact
fault
The instrument detected an intermittent contact
and shut down the laser output. If this is
triggering falsely (such as in a noisy
environment), the intermittent contact detection
can be disabled in the main menu.
E-537 Thermal trip Excessive power dissipated inside unit. Lower
voltage limit or add series resistance. See
“Thermal Considerations” for more details.
W-800 Remote voltage sense
is low When in remote voltage sense mode, the
ComboSource detected a significant difference
between the remote voltage and the voltage at
the connector, which may indicate a problem with
the remote voltage sense connection.
W-801 Burst Mode, Hold
Output When in Io (Burst) mode, to turn the output on,
the Output button must be held down for at least
one second. If it is held down for less than one
second, this warning message informs the user
than the Output button press did not turn the
output on.
E-998 Command not
supported A command was recognized but not supported
by the ComboSource.
E-999 Non-specific error A non-specific error was encountered.