Arris TM02AA104, Руководство по установке

Страница: 28 / 52

2-14 Installing the Telephony Modem
Touchstone ARSVD00770 Release 4 Standard 3.0 Aug 2004
Procedure 2-4 (continued)
Connecting the Telephony Modem
Making Ethernet Connections
7 Connect one end of the Ethernet cable to the Ethernet port on your computer,
and the other end to the port on the back of the Telephony Modem labeled
“Ethernet 10/100.”
Note: If you are connecting the Telephony Modem to a computer or the
Uplink (or MDI) port on an Ethernet hub or switch, use the supplied Ethernet
cable or a straight-wired (not “null” or crossover-wired) Ethernet cable. If you
are connecting the Telephony Modem to other ports (MDI-X) on a hub or
switch, make sure the Ethernet cable is a crossover-type cable.
8 Proceed to “Making Telephony Connections” as needed.
Making Telephony Connections
9 Connect one end of the telephone cable to a telephone or wall jack using a
standard RJ-11 connector. If installing a model TM402G, TM402H, TM402P,
or TM402Q go to step 10. If installing a model TM402A or TM402B go to
step 12.
10 Connect the other end of the cable to the connection on the modem labeled
“Tel 1/Tel2” using a standard RJ-11 connector.
11 If a second line of telephony service is required, do one of the following:
•
If you use a 4-conductor cable, you can use the “Tel1/Tel2” connector to
provide access to both lines. The red and green wires provide the first
line, and the yellow and black wires provide the second line.
• If you use a 2-conductor cable, connect the second telephone cable to a
telephone or wall jack, and the other end of the cable to the connection
on the Telephony Modem labelled “Tel2.”
12 Connect the other end of the cable to the connection on the modem labeled
“Tel 1” using a standard RJ-11 connector.
13 If a second line of telephony service is required, connect the other end of the
cable to the connection labeled “Tel 2”.
—end—
CAUTION
Make sure that the existing wires providing telephone service are
physically disconnected from the incumbant service provider’s
network interface device. This is a physical break in the
connection, not just a discontinuation of service. Failure to do so
will result in damage to the Telephony Modem.