Safety and Compliance
Advanced IP Client Video Set-top IPC1100
•
Installation and Operations Manual
ii
365-095-24769 x.1 10/13
During Installation
•
Do not place the cable terminal in an enclosed area where the cooling vents are blocked or impede the flow of air through
the ventilation openings.
•
Install the terminal so that its position does not interfere with its proper ventilation. For example, do not place the terminal
on a bed, sofa, rug, or similar surface that could block the ventilation openings.
•
Install the terminal away from heat sources such as radiators, heat registers and stoves. Installation of the terminal near
consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as the air surrounding
the terminal does not exceed 40º C (104º F).
•
Place the terminal on a flat surface not prone to vibration or impact.
•
Do not install the terminal in an area where condensation occurs.
•
To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do not plug the AC power
cord into a switched power outlet.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications not expressly approved by ARRIS for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
FCC Declaration of Conformity
ARRIS Enterprises, Inc., 101 Tournament Drive, Horsham, PA 19044, 1-215-323-1000, declares that the IPC1100 set-tops
comply with 47 CFR Parts 2 and 15 of the FCC rules as a Class B digital device.
