ARRI ARRIFLEX 235, Инструкция по эксплуатации

Страница: 43 / 178

43 43
Note: The magazine drive gear engages
automatically. In case it does not engage
properly, turn the magazine drive gear slightly
and try again.
• Check that the magazine is firmly seated.
• Open the movement by turning the inching knob
➪
photo
until the mark aligns with the mark on the movement
and then turn the movement locking lever
➪
photo
towards the “OPEN“ position.
• With your right hand pull the film loop downwards out
of the camera
➪
photo
. Then push it as far upwards
as possible so that the film collapses on the upper film
loop. Insert the loop between the movement plate and
the film gate.
• Bring the film loop into position
➪
photo
.
• Position the film by one perforation hole onto the
positioning pin
➪
photo
in the film guide, bringing
the film loop to rest within the marking
➪
photo
.
• Check that the film is correctly fixed on the positioning
pin. Check that the loop is positioned within the upper
marking, and that the film aligns with the film gate.
loop marking
Camera Body