Armstrong Medical 10190001, Руководство пользователя

Страница: 26 / 80

AquaVENT® FD140i, User Manual, English Issue 01 26
3.7 Breathing circuit set-up
AquaVENT
®
FD140i should be used with Armstrong Medical breathing circuits and components. For more
informaon refer to Appendix 2, “Accessories”. For specific therapy mode flow and pressure ranges
please refer to “Therapy Mode Technical Specificaons “table in Chapter 8
.
Before connecng a breathing circuit remove the port caps covering the respiratory gas outlet, Oxygen
inlet and Medical air inlet.
NOTE: The port caps should be retained for when the device is being transported for service or repair.
CAUTION
Ensure that the paent circuit respiratory limbs are not kinked or otherwise obstructed. Failure to do so
may introduce pressure build-up within the device .
3.8 Using a heater humidifier
Acve humidificaon should be used in all breathing circuits, other than for therapy mode Helmet CPAP.
The AquaVENT
®
FD140i can be used with any heater humidifier known to the manufacturer.
Device setup
WARNING
To prevent water from the humidificaon chamber from entering AquaVENT® FD140i, the following
instrucons must be observed:
•
The heater humidifier should be placed approximately 600mm below AquaVENT® FD140i.
•
When removing the acve humidifier from the breathing circuit, first disconnect the tube from
AquaVENT® FD140i .
Nebulised drug delivery
For instrucons in using the AquaVENT FD140i nebuliser funcon, please refer to Secon 4.13 “Using
with a nebulising system” .