Arjo Dual-Loop Attachment Straps, Инструкция по эксплуатации

Страница: 8 / 16

001-05415-EN rev
. 4
Using the DUAL-LOOP ATTACHMENT STRAPS 6
Using the Using the DUAL-LOOP ATTACHMENT STRAPS DUAL-LOOP ATTACHMENT STRAPS
Using the Ferno Scoop EXL Stretcher
with the Maxi Move
Lifting from a Bed or Hospital Stretcher
The following procedure should only be performed
using the
DUAL-LOOP ATTACHMENT STRAPS
.
WARNING : Inspect the straps prior to each use.
See “Straps Inspection” on page 8. Never
use a strap if damaged or badly worn as it may
result in the patient falling, causing injuries.
WARNING : To prevent the Maxi Move from
tipping, resulting in patient falls and injuries, the
Maxi Move must be used with legs open at all
times. The patient should be kept at nearly bed
height or lower and transfers must always be
performed on flat, level surfaces or floors.
1) Install the stretcher frame on the Maxi Move
(refer to the
Maxi Move Instructions for Use
No.001.25060.**
).
2) Position the patient onto the Ferno Scoop EXL
Stretcher (refer to the product’s Users’ Manual).
3) Make sure that the
DUAL-LOOP ATTACHMENT
STRAPS
have been installed in the correct
locations. If the four straps have not yet been
attached to the
Ferno Scoop EXL Stretcher,
proceed to attach them according to the precise
locations and in the correct way as shown in
Fig. 3.
Fig. 3
4) Bring the stretcher frame over to the patient and
align the stretcher frame’s suspension point
labels with the installed attachment straps.
Lower the stretcher frame sufficiently to be able
to connect the attachment straps securely on
the hooks (See Fig. 4).
Fig. 4
WARNING
: When lowering the stretcher frame,
over the patient, be careful that it does not
accidentally strike the patient.
5) Attach all the straps to the stretcher frame.
Choose the loop to use (long or short) at
head section and at foot section depending
on patient’s morphology. Most of the time long
loops can be used everywhere. See Fig. 5.
Fig. 5
WARNING : Use only the hooks identified by the
“Suspension Point” labels (see Fig. 5), on the
stretcher frame to attach the
Ferno Scoop EXL
Stretcher
to the frame. Failure to follow these
instructions may result in patient falls causing
injuries.
WARNING : Always check that all the
DUAL-
LOOP ATTACHMENT STRAPS
remain secured
as the patient’s weight is taken up. A strap that
is incorrectly fastened could detach, resulting in
the patient falling.
Install the
DUAL-LOOP
ATTACHMENT
STRAPS only in
the handholds
indicated by the
green circles.
Use hooks
indicated by
labels only
Use hooks
indicated by
labels only