CS175-275-575-875 Installation Guide
123
4
On: the event follows schedule 4.
5
On: the event follows schedule 5.
6
On: the event follows schedule 6.
7
On: the event follows schedule 7.
8
On: the event follows schedule 8.
Location 3
Programming the X-10 address for output 1 (two segments, ND)
Segment 1
Program a number from 0 to 15 to represent the corresponding X-10
module number from the following table.
Module #
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16
Seg 1
0 1 2 3 4 5 6 7 8 9 10 11 12
13 14 15
Segment 2
Program a number from 0 to 15 to represent the corresponding X-10
house code from the following table.
0 = A
4 = E
8 = I
12 = M
1 = B
5 = F
9 = J
13 = N
2 = C
6 = G
10 = K
14 = O
X-10
ADDRESS
CODES
3 = D
7 = H
11 = L
15 = P
Locations 4 - 31
Programming for outputs 2 to 7
"
The information in the following locations is configured in the same way as locations 0, 1,
2 and 3 for output 1.The following table contains the locations for output 1 to 7, output 8
is reserved. Output 8 may be used for X10, but is not a physical output.
Description
Output1 Output2 Output3 Output4 Output5 Output6 Output7
Event
0 4 8 12 16 20 24
Functions
1 5 9 13 17 21 25
Schedules
2 6 10 14 18 22 26
X10
Programming
3 7 11 15 19 23
27
Locations 4 to 31 are used to program the events, zones and times, special functions,
partitions, schedules and X-10 addresses for outputs 2 to 7. Each output has four
locations which are programmed with the same steps as output 1. See
Location 0
,
Location 1
,
Location 2
and
Location 3
above for more information.
