8
Complete Preparation
1.
If not yet attached, install the 6” (15.2 cm) vent transition the
top of the range hood liner using two 3.5 x 9.5 mm screws.
2.
Locate side mounting bracket flush 1 cm to the bottom of the
cabinet side and against the inside of the front cabinet face.
Orient the bracket depending on the width of your cabinet
as depicted in the diagrams below. Using the bracket as a
template, mark 4 spots in each side of the cabinet to drill
1
⁄
8
”
(3 mm) pilot holes. Attach a bracket using four 4.5 x 13 mm
screws to each side of the cabinet, and tighten. Additional
washers in hardware package are supplied as spacers for
cabinet walls thinner than ½” (13 mm).
Bracket Orientation for 30” (76.2 cm) Cabinet
A
B
C
D
A. 30” (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C.Washers (optional)
D. Mounting bracket (2) (position for 30” [76.2 cm] cabinet)
Bracket Orientation for 36” (91.4 cm) Cabinet
A
C
B
D
A. 36” (91.4 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C.Washers (optional)
D. Mounting bracket (2) (position for 36” [91.4 cm] cabinet)
Move the bracket
6
⁄
16
” (1 cm) from the bottom
side of the cabinet.
NOTE: For 11
11
⁄
16
” (29.7 cm) depth cabinets,
the bracket must be centered to lateral walls.
3.
Install the vent system according to the method needed. Use
caulking to seal the exterior wall or roof opening.
WARNING:
Excessive Weight Hazard.
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
4.
Using 2 or more people, lift the hood liner into its mounted
location. Attach with four 4.2 x 19 mm screws into the slotted
openings. Do not tighten screws.
A
B
C
A.Cabinet
B.Hood liner canopy assembly
C. Screws - 4.2 x 19 mm (8)
5.
Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2x19 mm
screws into the round mounting plate openings.Remove the
metal grease filters from the face panel. See the “Range Hood
Care” section.
6.
Connect the lamp electrical connector.
7.
Attach the face plate to the hood insert.
NOTE:
If cabinet depth is greater than 12”, it is recommended
that the two
1
⁄
2
” metal spacers are installed before attaching to
the hood insert.
8.
Install to front and rear sides of the face plate with 3.5 x 9.5
mm screws as shown in drawing.
C
A
C
B
A.Face Panel
B.Front and rear spacer
C. Screws - 3.5 x 9.5 mm (4)