10
MODEL:
A
B
C
D
A. Blower and LED lamps controls
B. Grease filter
C. Grease filter handle
D. LED lamps
1. Light On/Off button
2. Blower On/Off button
3. Blower speed minimum button
4. Blower speed medium button
5. Blower speed maximum button
NOTE:
Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (1) controls both lights. Press once
for On and again for Off.
Operating the blower
The Blower On/Off button (2) turns the blower On or Off.
The Blower Speed buttons (3, 4 and 5) set the desired speed and
control the sound level for quiet operation. The speed can be
changed anytime during fan operation by pressing the desired
blower speed button.
1.
To turn the blower On, press the Blower On/Off button (2) and
the desired speed button (3, 4 or 5).
2.
To turn the blower Off, press the Blower On/Off button (2).
Any of the 3 blower speed buttons can be in the On position
at the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.
Range Hood Care
Range Hood Controls
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
• Liquid detergent soap and water, or all-purpose cleanser
• Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
Let filter dry thoroughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1.
Remove each filter by pulling the spring release handle and
then pulling down the filter, or by pulling outwards the spring
and removing the filter.
A
A
A. Spring release handle
2.
Wash metal filters as needed in dishwasher or hot detergent
solution.
3.
Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper track.
4.
Pull the spring release handle down.
5.
Push up on metal filter and release handle to latch into place.
6.
Repeat steps 1-5 for the other filter.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
the service contact information in the next page.