Aria-24
ipe
Digital Key Telephone System
Installation Manual
Issue 1.5
Aria Technologies
57
4.3
Base Station Installation
There are two ways in installing the base station:
4.3.1 Mounting Base Station
– 1
The weight of a base station is light as approx. 460g, so it can be mounted on a masonry or dry-wall
surface, wooden wall, or partition wall. The distance between mounting holes is 121mm as shown below.
The base station is mounted with 1 1/2 inch or longer screws. Drill pilot holes in the two locations, insert
the screws and tighten leaving about 3mm gap between the wall and screw head. Mount the base
station on the screws and tighten the screws securely.
Figure 4.3-1 The back side of the GDC-400B
Before mounting base station permanently, you should determine locations that provide the best
coverage. The wall mounting procedure of a base station is as follows:
1.
Drill two 3.5mm holes in a fixed wall. To properly position the holes, you can use mounting template
that is the last sheet of this manual and copy it if necessary.
2.
Insert anchors into the drilled holes. Then insert screws in the anchors, leaving a 3mm gap between
the wall and screw head.
3.
Mount the base station eyelets on the screws.
