Arfa 1018S, Инструкция по эксплуатации

Страница: 17 / 36

14 ADJUSTING CUTTING PRESSURE OF
SAW ARM
Fig. 11
The cutting pressure of the saw arm has
been set at the factory and should not need
further
adjustment. If adjustment should ever
become necessary, lower the saw arm to
the horizontal
position. Loosen locknut (A) Fig.11. until the
pressure is increased or decreased.
15 OPERATING AND ADJUSTING VISE
Fig.12
The workpiece is placed between the vise
jaws with the amount to be cut-off extending
out past the blade. Your machine is
equipped with a “quick action” vise jaw
which allows you to instantly position the
moveable vise jaw (B) Fig. 12.’ Simply turn
hand wheel (A) counterclockwise 1/2 turn
and move `the vise jaw (B) to the desired
position. Then tighten the vise jaw (B)
against the workpiece by turning hand wheel
clockwise. The vise can be adjusted to cut
any angle from a straight 90 degree cut-off
to a 45 degree angle by loosening the
two sp ring-loaded clamp handles (one
located on each vise jaw), positioning the
vise jaws to the desired angle and
tightening the tow spring-loaded handles.
The right vise jaw is provided with
positive stops to instant-ly position the
jaw at 90 or 45 degrees. To check and
adjust the positive stops, roceed as
follows:
Fig. 13
1. Pivot the right vise jaw (C) Fig. 13. All
- - 15