Arfa 1018S, Инструкция по эксплуатации

Страница: 14 / 36

8 STARTING AND STOPPING MACHINE
1. Raise the saw frame to the up position.
2. The machine is started by pushing the
start button (C) Fig. 2. And it will
continue to run until the saw arm is in the
down position at the end of the cut, or
when the stop button (D) is pushed.
3. When in emergency push button (D) to
stop the machine. After removing the
trouble, release emergency button,
re-start the machine by pushing the start button (C).
Fig. 2
A D C B F G
4. When using the coolant turn the select button (A) to the right.
5. To adjust the feeding rate when in cutting, turn the volume valve (F) clockwise for faster
feeding, counterclockwise for slower feeding. When volume valve (F) has been properly
adjusted, turn the control valve (G) to handle saw arm action.
6. An automatic shut-off limit switch is
provided to stop the motor when the cut is
completed. The limit switch (D) is controlled by
a lever Fig. 3, which contacts the top of the
hydraulic cylinder (E) shutting off the motor
and coolant pump.
E Fig. 3 D F
7. If the motor stops before the cut is
completed or con-tinues to run after the cut is
completed, the limit switch(D) Fig. 3. Can be
adjusted up or down by loosening the two
screws (F).
9 ADJUSTING DOWNWARD TRAVEL OF
SAW ARM
The downward travel of the saw arm should be
adjusted so that when the saw arm is in the
extreme downward position, the teeth of the
blade are 1/16” below the tab-le surface. If an
adjustment is necessary, loosen lock nut (A)
Fig. 4. And turn stop screw (B) in or out until
the correct adjustment is made. Then tighten
lock nut (A).
A Fig. 4 B
- - 12