Arfa 1018S, Инструкция по эксплуатации

Страница: 22 / 36

21 GEAR BOX
The gear box should be drained and
refilled after the first 50 hours of use and
thereafter every 5 months, with mobil
synthetic gear oil, SHC-636, ISO viscosity
grade 680. this oil meets or exceeds
american gear manufacturers association
(A.G.M.A.) #8 compounded cylinder oil
specifications. this oil is available through
grainger's in 1 quart bottles as number
SW061.
Fig. 24
To change the gear box oil, proceed as
follows:
1. Run the machine for 10 minutes to warm
up the gear box.
2. Disconnect the machine from the power source.
3. Raise the saw arm to its maximum position
and close the feed rate control knob.
Fig. 25
4. Drain the gear box by removing screw (A) Fig.
24.
5. Replace screw (A) Fig.24. and lower the saw
arm to its lowest position.
6. Remove oil breather nut (B) Fig.25.
7. Fill the gear box with oil through the oil hole (B)
until the oil reach 1/3 volume in the oil window.
Then replace oil breather nut (B) .
- - 20