Ares Crusader II PTF, Руководство пользователя и техническая информация

Страница: 10 / 24

10
KA-6 Transmitter Functionality
For a full description of your KA-6 transmitter’s features and functions refer to
the online KA-6 instruction manual located here: http://ikonnik-rc.com/KA6/
support.asp
1. Digital trims: Your KA-6 transmitter has digital trims on all for primary
controls – aileron; elevator; rudder; throttle. Each movement of the trim
button is audibly highlighted by a single short beep, whilst trim center is
highlighted by a single longer beep.
2. Servo reverse: The rotation direction of the servos can be individually
reversed using the Servo Reversing Switches located on the front facia.
3. Fail Safe: In the event of signal loss the KA-6 is equipped with a fail-safe
function which operates across all 6 channels and must be set independent
of the pairing process.
4. Delta Mix: Whilst the KA-6 can be used to control delta aircraft (or a flying
wing) for Crusader II operation the Delta Mix switch must be set to FIXED
WING.
Charging the Supplied LiPo Battery
Read and fully understand the section headed LI-PO BATTERY WARNINGS and
never leave LiPo batteries unattended whilst charging.
• Plug the mains power adaptor into a wall socket and connect the charger
to the power adaptor using the circular DC socket. Note that the green LED
‘Power’ indicator on the charger will light.
• Place the charger on a flat, heat resistant surface (not carpet) with a good
airflow all around. Ensure the vent openings on the bottom and sides of the
charger are not blocked. Connect the supplied 3S 2200mAh LiPo battery
to the charger using the white three pin balance plug, ensuring the correct
orientation of the plug. The red ‘Charger’ LED will light indicating that
the battery is charging. When fully charged the red LED will stop glowing,
whereupon the battery can be disconnected.
UP