20
ARES™ HIGH-SECURITY STEEL FENCING
Measure from
inside face of
I-Beam Post
Fig. 40
Fig. 41
Measure the panel opening
Step 2:
Mark Panel with Cut Points
1. Minus 1-3/4” [45mm] from measured Panel opening
length to account for the indent in I-Beam to allow panel
to be inserted.
2. Use the determined length above as the cut Panel length.
3. Find the center of the Panel and measure out half of
the previously determined length in each direction.
4. Mark the cut points with a Silver Sharpie on the rails of the
Panel. As shown in Fig. 42.
Be sure cut marks are in line.
Note:
• Before cutting the Panel, confirm the desired cut length
DOES NOT interfere with the pickets.
• For a successful installation of the cut Panel, confirm the
cut rail ends overhang a
minimum of 2” [51mm] from the
outer face of the end picket. As shown in Fig. 43. This
length is required to notch the rail ends and drill bolt holes.
Fig. 42
Panel Cut 1
Center of Panel
Panel Cut 2
FRONT VIEW
Front View
Содержание Citadel Panel
Страница 1: ...ARES HIGH SECURITY STEEL FENCING 1 ARES HIGH SECURITY STEEL FENCING INSTALLATION INSTRUCTIONS ...
Страница 11: ...ARES HIGH SECURITY STEEL FENCING 11 Fig 10 Fig 9 Fig 8 Fig 11 Fig 14 Fig 13 Fig 12 ...
Страница 13: ...ARES HIGH SECURITY STEEL FENCING 13 Fig 20 Fig 19 Fig 18 Fig 21 Bolt holes on rail bracket aligned ...
Страница 25: ...ARES HIGH SECURITY STEEL FENCING 25 ...
