Arecont Vision
Surround
Video
®
Omni Installation Manual
Page | 10 [email protected]
Surround
Video® Omni
Installation
1.
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all
local codes and authorities having jurisdiction. Wiring should be UL Listed and/or Recognized wire
suitable for the application.
2.
Operating Temperature -40°C (-40°F) to +50°C (122°F)
3.
Always use hardware e.g. screws, anchors, bolts, locking nuts etc. which are compatible with mounting
surface and of sufficient length and construction to insure a secure mount
4.
Visit
http://www.arecontvision.com/
and check to ensure your camera has the most current firmware.
5.
If using the NPT port always use Teflon tape around threads to ensure proper sealing.
6.
After plugging in the network cable check that the indicator LED’s are indicating the desired conditions
(see LED Indicator table).
7.
Use Arecont Vision software AV200 located on the CD or available for download at our website
(
www.arecontvision.com
) for camera discovery and setup (see Instruction Manual located on CD or
available on our website).
8.
Adjust the individual cameras to obtain the desired fields of view (see Focusing Instructions).
9.
Lens may be further secured by tightening the lens lock screw using Phillips head screwdriver.
10.
Install the Dome Cover by aligning the captive fasteners with the mating threaded holes on the camera
housing.
11.
When mounting the Dome Cover to the Camera Housing ensure that the gasket is properly seating and
not folded. Failure to do so may result in water and dust ingress.
Best Practice Tips
When mounting to vertical surface it is best to use the Wall Mount Accessory which includes a Junction
Box.
For outdoor use it is always best to properly seal the product using caulk around the edges to prevent
water ingress from mounting to porous or uneven surfaces.
Use Teflon tape on threaded interfaces.