Arduino All-In-One, Руководство по эксплуатации

Страница: 8 / 13

Setting Mode
To enter setting mode, press the button for more than 1 second (“medium press”). The “RGB back light”
LEDs will start to flash white. The number of consecutive flashes indicates the mode you are in.
Each medium press of more than 1 second will move the setting mode onto the next. When you finish the
setting modes, the clock returns to normal time display mode.
To exit
the setting mode before going through all the options, press the button for more than 2 seconds
(“long press”). The “RGB back light” LEDs will return back to their normal operation. Another way of exiting is
to cycle through all of the setting options, after which you will return to time mode.
To change a setting, press the button for less than one second, and then release it (“short press”).
Mode Description Values
Time mode.
This is the normal mode and displays the time. It is
the normal start up mode of the clock. If you do nothing. The clock is
in this mode.
In this mode a short press cycles through the values given in “Time
Display Mode”, but always returns to the standard time display after
5 seconds.
Time and Date Settings
Note that the Time and Date settings will not be shown if the WiFi module is active!
Set Hours.
Each short press will advance the hour. The hours roll
over back to zero after reaching 12 or 24 (depending on the 12/24
hours mode).
Set minutes.
Each short press will advance the minute. The
minutes roll over back to 0 ffter reaching 59 minutes. Each time you
set the minute, the seconds is reset to 0.
Reset seconds.
Each short press will reset the seconds to 0,
without changing the hours or minutes.
Set Day.
Each short press will advance the day. The day roll over
back to one after reaching the maximum number of days in the
month.
Set Month.
Each short press will advance the month. The month
roll over back to zero after reaching 12.
Set Year.
Each short press will advance the year. The year roll over
back to 2015 after reaching 2099.