Arctic Cat VLX 70002017, Руководство по обслуживанию

Страница: 44 / 138

43

NOTE: If the paint is not visible, install the ends of
the springs with the closest wound coils toward the
head.
ATV-1011A
4. Place a spring retainer over the valve springs; then
using the valve spring compressor, compress the
valve springs and install the valve cotters.
CC132D
PISTON ASSEMBLY
 NOTE: Whenever a piston, rings, or pin are out of
tolerance, they must be replaced.
Inspecting Piston
1. Inspect the piston for cracks in the piston pin, dome,
and skirt areas.
2. Inspect the piston for seizure marks or scuffing.
Repair with #400 grit wet-or-dry sandpaper and
water or honing oil.

NOTE: If scuffing or seizure marks are too deep to
correct with the sandpaper, replace the piston.
3. Inspect the perimeter of each piston for signs of
excessive “blowby.” Excessive “blowby” indicates
worn piston rings or an out-of-round cylinder.
Removing Piston Rings
1. Starting with the top ring, slide one end of the ring
out of the ring-groove.
CC400D
2. Remove each ring by working it toward the dome of
the piston while rotating it out of the groove.

NOTE: If the existing rings will not be replaced with
new ones, note the location of each ring for proper
installation. When installing new rings, install as a
complete set only.
Measuring Piston-Ring End Gap
(Installed)
1. Place each compression ring in the wear portion of
the cylinder. Use the piston to position each ring
squarely in the cylinder.
2. Using a feeler gauge, measure each piston-ring end
gap. Acceptable ring end gap must not exceed speci-
fications.
CC280D
Measuring Piston Pin (Outside
Diameter) and Piston-Pin Bore
1. Measure the piston pin outside diameter at each end
and in the center. If measurement is not within speci-
fications, the piston pin must be replaced.
ATV-1070