Arctic Cat M 1100 Turbo, Руководство оператора

Страница: 38 / 68

34
2. Remove the torx-head screws and
the access plate from beneath the
snowmobile.
3. Place a drain pan beneath the engine oil
pan drain plug; then remove the plug
and allow the oil to drain completely.
PC010A
4. Install the engine oil drain plug with
a new gasket; then tighten the plug
to 16 ft-lb.
5. Remove the four torx-head screws
securing the right-side footrest to the
tunnel and the support; then with a
drain pan in position, remove the
drain plug from the oil reservoir.
746-121A

NOTE: To aid in draining the oil
from the reservoir, position a funnel
between the reservoir and the open-
ing of the tunnel running board.
6. After the oil has drained completely,
install the drain plug with a new O-
ring and tighten to 16 ft-lb.

NOTE: Always install a new Oil Pan
Drain Plug Gasket (p/n 3402-011) and
a new Reservoir Drain Plug O-Ring (p/
n 1602-213) when changing the oil.
7. Using Oil Filter Wrench (p/n 0644-
551), loosen (but do not remove) the
oil filter and allow the oil to drain
from the filter into the drain pan;
then remove the filter.

NOTE: On the turbo models, the oil
filter is accessible between the front
opening of the chassis and the lower
intercooler hose.
8. Apply a light coat of fresh engine oil
to the seal of the new oil filter.
9. Install the new oil filter by turning
the oil filter by hand until the seal
has contacted the oil filter mounting
surface; then tighten the oil filter to
15 ft-lb. Remove the drain pan.
10. Pour 2.9 l (3 U.S. qt) of the recom-
mended engine oil into the oil reservoir.
11. Open the air bleed bolt located on
the oil pump (beneath the coolant
tank) to purge air from the oil hose.
PC016A

NOTE: When air can no longer be
heard purging from oil pump bleed,
tighten the bleed bolt to 7.5 ft-lb.
12. Without starting the engine, place
the handlebar emergency stop
switch to the RUN position and the
ignition switch to the ON position.
The Oil Pressure Warning Icon
should illuminate.

NOTE: If the warning icon does not
illuminate, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for service. If not under war-
ranty, this service is at the discretion
and expense of the snowmobile owner.
13. If the warning icon illuminates
(from step 12), start the engine. The
warning icon should go out within
five seconds. If it does, proceed to
step 14.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.