Arctic Cat M 1100 Turbo, Руководство оператора

Страница: 42 / 68

38

NOTE: For installing purposes,
note the side that the servomotor
cables are installed on.
3. Slide each cable drum out of the slot
of the servomotor actuator.
4. While holding the cable housing
firmly, pull the cable as far out as it
will go; then release. Repeat three to
four times. The cable/exhaust valve
should move freely without binding.

NOTE: If the cable/exhaust valve
does not move freely, the exhaust valve
assembly will need to be removed for
further inspection. Take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for this service.

NOTE: When measuring the cables,
they are to be routed as close to their
installed position as possible.
5. While holding the cable housing,
lightly pull on one cable end to
remove any slack; then measure the
amount of exposed cable from the
cable housing to the end of the cable
(cable drum).
0735-516

NOTE: The two cable measure-
ments must be equal in length or
less than 0.5 mm (0.020 in.) differ-
ence in length from each other.

NOTE: Repeat steps 4 and 5 for each
cable; then compare the measure-
ments to the APV Cable Length chart.

NOTE: The measurements must be
within the specifications from the
chart. If the measurements are
within specifications, no adjustment
is necessary (proceed to step 8). If
they are not within specifications,
proceed to step 6.
6. Loosen the jam nut on the cable to
be adjusted; then using the adjusting
nuts, lengthen or shorten the housing
as needed.
7. Once the proper length has been
attained, hold the adjusting nut in place
and tighten the jam nut securely.
8. Place the cable housings into posi-
tion in the servomotor. Secure the
cable housings with the cable holder.
Battery (Electric Start)
These sealed batteries after being in ser-
vice require regular cleaning and
recharging in order to deliver peak per-
formance and maximum service life. The
following procedures are recommended
for cleaning and maintaining sealed bat-
teries. Always read and follow instruc-
tions provided with battery chargers and
battery products.

NOTE: Battery maintenance may
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
To remove and charge the battery, use the
following procedure:
CAUTION
Do not use the nut securing the pul-
ley to the servomotor to rotate the
actuator.
APV CABLE LENGTH
800 cc 1.377 in. ± 0.039 in.
CAUTION
Assure the cables are rotated and
secured properly to avoid contacting
exhaust components.
! WARNING
Any time service is performed on a
battery, the following must be
observed: Keep sparks, open flame,
cigarettes, or any other flame away.
Always wear safety glasses. Protect
skin and clothing when handling bat-
teries. When servicing battery in
enclosed space, keep the area well-
ventilated.