Arctic Cat HDX 500 2017, Руководство по обслуживанию

Страница: 169 / 190

168
CD019
2. Inspect boots for any tears, cracks, or deterioration.
 NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
DISASSEMBLING AXLES

NOTE: Only the boots are serviceable on the axles;
if any other component is worn or damaged, the axle
must be replaced.
1. Using CV Boot Clamp Tool, remove and retain both
clamps for assembly purposes.
HDX390
2. Use a suitable form of protection on the outside sur-
face of the CV joint, such as a strip of rubber or duct
tape; then place the CV joint housing into a vise.
CF335 HDX391
3. To disengage the axle from the CV joint, sharply pull
back on the axle; then slide the boot off of the axle.
HDX392

NOTE: Steps 1-3 can be used to replace the out-
board boot.
ASSEMBLING AXLES
1. Install the inner boot with the small clamp making
sure the ends of the clamp are positioned correctly.

NOTE: Position the end of the clamp opposite the
forward rotation of the axle.
HDX393A

NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
2. Using the boot clamp tool, secure the small clamp of
the inner boot.
ATV-1048
3. Apply 80 grams (2/3 of contents) of grease from the
pack into the bearing housing.
CAUTION
Do not over tighten the vise when securing the CV joint
housing, otherwise internal damage to the CV joint may
occur.