Arctic Cat HDX 500 2017, Руководство по обслуживанию

Страница: 122 / 190

121
2. Lightly oil all bearings and grease all shafts in the
right-side crankcase.
3. Using a plastic mallet, lightly tap the case halves
together until cap screws can be installed.
4. From the right side, install the 8 mm cap screws;
then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
5. From the left side, install the remaining 8 mm cap
screws (two inside the case); then tighten only until
snug.
 NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
6. From the left side, install the case half 6 mm cap
screws; then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
7. From the right side, install the 6 mm cap screws;
then tighten only until snug.
 NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
8. In a crisscross/case-to-case pattern, tighten the 8 mm
cap screws (from steps 4-5) until the halves are cor-
rectly joined; then tighten to 20 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
9. In a crisscross/case-to-case pattern, tighten the 6 mm
cap screws (from steps 6-7) to 10 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
Installing Engine/
Transmission

NOTE: Arctic Cat recommends new gaskets and O-
rings be installed whenever servicing the vehicle.
1. On the 700, place the engine spacers in position; then
using new lock nuts, install the two cap screws
securing the engine brackets to the engine. Tighten to
42 ft-lb.
2. On the 500, verify all four rubber mounts are
inserted into each corner of the crankcase; then using
new lock nuts, install the two cap screws securing
both engine brackets to the engine. Tighten to 42 ft-
lb.
3. Using a suitable lifting sling and engine hoist, lower
the engine into the vehicle engaging the slotted front
and rear engine mount brackets with the engine
mounts.
4. Tighten the flange nuts (700) or bolts (500) on the
front and rear cradle to 25 ft-lb.
HDX314A
HDX288A
5. Secure the front and rear driveshafts to the engine
flanges with the cap screws and tighten to 20 ft-lb.
HDX288

AT THIS POINT
After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Com-
ponents.
700
500
Rear