Arctic Cat Crossfire 700 EFI (EB) 2006, Руководство оператора

Страница: 44 / 52

40 PREPARATION AFTER STORAGE
PREPARATION AFTER STORAGE
Taking the snowmobile out of stor-
age and correctly preparing it for
another season will assure many
miles and hours of trouble-free
snowmobiling. Arctic Cat recom-
mends the following procedure:
1. Clean the snowmobile thor-
oughly. Polish the exterior of
the snowmobile.
2. Clean the engine. Remove the
cloth from the exhaust system.
Check exhaust system and air-
intake silencer for obstructions.
3. Inspect all control wires and
cables for signs of wear or fray-
ing. Replace if necessary. Use
cable ties or tape to route wires
and cables away from hot or
rotating parts.
4. Inspect the drive belt for cracks
and tears. Check belt specifica-
tions. Replace if damaged or
worn. Install the drive belt.
„
NOTE: If the old belt is worn but
in reasonable condition, retain it
with the snowmobile as a spare in
case of emergency.
5. Inspect all fuel hoses and oil
hoses for deterioration or
cracks; replace if necessary.
Make sure all connections are
tight; then fill the oil-injection
reservoir with recommended
APV oil.
„
NOTE: After prolonged storage,
Arctic Cat recommends one tank-
ful of 100:1 gas/oil mixture be
used in conjunction with the oil-
injection system to ensure proper
lubrication.
6. Check the coolant level and all
coolant hoses and connections
for deterioration or cracks. Add
properly mixed coolant as nec-
essary.
7. Inspect the entire brake system
(fluid level, pads, etc.), all con-
trols, headlight, taillight, brake-
light, ski alignment, ski wear
bars, and headlight aim; adjust
or replace as necessary.
8. Inspect the spark plugs.
Replace, gap, or clean as neces-
sary.
9. Adjust the track to the proper
tension and alignment. Lock the
jam nuts.
10. Inspect the throttle cable for
condition and for proper adjust-
ment.
11. Tighten all nuts, bolts, and cap
screws making sure all cali-
brated nuts, bolts, and cap
screws are tightened to specifi-
cations.
12. Lubricate the rear suspension,
spindles, and driven shaft sup-
port bearing with a low-temper-
ature grease.
13. Place the rear of the snowmo-
bile on a shielded safety stand;
then start the engine. Allow the
engine to idle; then using a long
stiff wire with a hooked end,
raise the oil-injection pump
control arm to the wide-open
position until the engine starts
to smoke heavily. Release the
control arm and turn off the
engine.