Arctic Cat Crossfire 700 EFI (EB) 2006, Руководство оператора

Страница: 37 / 52

MAINTENANCE 33
727-720A
To rotate an adjusting cam, use the
spark plug wrench from the tool kit.
Rotate the wrench until the cam is in
the desired position. To stiffen the
ride, rotate the cam so as to raise the
spring end. Make the adjustment on
the other cam and be sure both cams
are adjusted equally.
LIGHTS
The correct taillight/brakelight bulb
is p/n 0109-460. The correct head-
light bulbs are p/n 0609-251 for the
high beam and p/n 0609-693 for the
low beam.
Removing and Installing
Taillight/Brakelight Bulb
1. Remove the screws securing the
taillight/brakelight lens; then
remove the lens.
0739-712
2. Push in on the bulb and rotate it
counterclockwise to remove it
from the socket.
3. Install the new bulb in the
socket by pushing it in and
rotating it clockwise.
4. Install the lens and secure with
the screws.
Removing Headlight Bulb
„
NOTE: The bulb portion of the
hea dl ight is fragile . HA ND LE
WITH CARE. When replacing the
headlight bulb, the bulb assembly
must first be removed from the
housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing.
To access the headlight bulbs, use
the following procedure.
1. With the hood closed, loosen
the headlight adjustment knobs.
2. Carefully push the headlight
lenses rearward far enough to
remove the torx-head screws
securing the air silencer plenum
to the hood.
3. Open the hood; then remove the
O-rings securing the air silencer
plenum to the hood and remove
the air silencer plenum to
access the bulbs.
4. Remove the bulb from the
headlight housing and discon-
nect the wiring harness from the
bulb.
737-299A
! CAUTION
N ev e r fo rc e t h e a d j u s t m e n t
cams from the low position to
the high position. Cam damage
may occur.