Arctic Cat Crossfire 700 EFI (EB) 2006, Руководство оператора

Страница: 16 / 52

12 GENERAL INFORMATION
3. Using a wrench to secure the
stud, tighten the lock nut on the
exposed stud.
It is also recommended that when-
ever studs are installed on a track,
c a r b i d e w e a r b a r s s h o u l d b e
installed on the skis. Carbide wear
bars complement the track studs to
balance steering control under these
conditions. The length of the carbide
on the wear bars should be propor-
tionate to the number of track studs
(i.e. small number of track studs -
short length of carbide...many track
studs - long length of carbide). The
proper proportion between the num-
ber of studs and carbide length on
the wear bar will maintain steering
balance.
„
NOTE: Stud or hooker plate
installation will void track and
tunnel warranty.
TOWING
If the snowmobile is to be towed by
another snowmobile, do not tow
using the loops in the skis. The tow
rope should be attached to the spin-
dles.
HIGH ALTITUDE OPERATION
Operating a snowmobile at varying
altitudes requires changes in perfor-
mance components. These changes
affect drive train.
„
NOTE: This snowmobile is ini-
tially set up for operation between
0-5000 feet.
„
NOTE: Drive train changes can
b e m a d e by t h e s n o w m o b i l e
owner if qualified to do so. If the
owner does not feel qualified,
take the snowmobile to an autho-
r i z e d A rc t i c C a t S n ow m o b i l e
dealer for this service.
REMOVABLE SEAT
This snowmobile is equipped with a
removable seat. To remove the seat,
use the following procedure:
1. On the bottom of the seat-base,
press the retaining clips away
from locking pins.
2. Lift on the back of the seat and
move it rearward to remove it
from the tunnel.
To install the seat, use the following
procedure:
1. Slide the front of the seat into
position on the tunnel; then
lower the rear of the seat onto
the locking pins.
2. Press down on the rear of the
seat until the retaining clips
snap into place on the locking
pins.
! WARNING
Always balance the snowmo-
bile with the proper proportion
between the number of studs
and carbide length on the wear
bars. Do not “over drive” condi-
tions; use common sense in all
operating conditions.
! WARNING
Do not operate a snowmobile
with loose studs as they may be
thrown from the track. Always
use a shielded safety stand
whenever performing any main-
tenance or adjustments.
! WARNING
Make sure the seat is securely
lock ed in place or person al
injury may result.