Arctic Cat 550 H1 EFI, Руководство пользователя

Страница: 60 / 71

58
Tubeless Tire Repair
Should a leak or flat tire occur due to a
puncture, the tire may be repaired using
a plug-type repair. If the damage is from
a cut or if the puncture cannot be
repaired using a plug, the tire must be
replaced. When operating the ATV in
areas where transportation or service
facilities are not readily available, it is
strongly recommended to carry a plug-
type repair kit and a tire pump along.
WHEELS
1. Park the ATV on level ground and
engage the parking brake lock.
2. Loosen the lug nuts on the wheel to
be removed.
3. Elevate the ATV by placing a jack
under the axle.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Tighten the nuts in a crisscross pat-
tern to 4.4 kg-m (32 ft-lb).
8. Remove the jack.
LIGHT BULB
REPLACEMENT
The wattage rating of each bulb is
shown in the chart. When replacing a
burned bulb, always use the same watt-
age rating.
Headlight
„
NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
To replace the headlight bulb, use the
following procedure.
1. Remove the rubber boot from the
back of the headlight housing; then
remove the three-wire connector
from the bulb.
2. Release the two ends of the spring
clip from the headlight housing
making sure not to bend or deform
the clip; then remove the bulb from
the housing.
3. Install the new bulb into the housing;
then secure with the spring clip.
CAUTION
When breaking the tire bead loose
from the wheel, be extremely careful
not to damage the inner wheel sur-
face or the tire bead.
! WARNING
Use only Arctic Cat approved tires
when replacing tires. Failure to do
so could result in unstable ATV
operation.
! WARNING
Failure to tighten the lug nuts to
specified torque value can be haz-
ardous. If the nuts are not properly
tightened, the wheel can come off
causing an accident and possible
severe injury.
Headlight 12V/35W/35W
Taillight/Brakelight 12V/5W/21W
License Plate Light 12V/5W
Turn Signal - Front 12V/27W
Turn Signal - Rear 12V/10W
Position Light - Front 12V/5W
CAUTION
Use only specified bulbs indicated
in the chart as replacement bulbs.
! WARNING
Do not attempt to remove the bulb
when it is hot. Severe injury may
result.