Arctic Cat 550 H1 EFI, Руководство пользователя

Страница: 57 / 71

55
GE
NE
RAL M
AINTE
NANCE
6. After charging the battery for the
specified time, remove the battery
charger and allow the battery to sit
for 1-2 hours.
7. Connect the multimeter and test the
battery voltage. The meter should
read at least 12.5 DC Volts. If the
voltage is as specified, the battery is
ready for service.
„
NOTE: If voltage in step 7 is
below specifications, charge the
battery an additional 1-5 hours;
then retest.
8. Place the battery in the battery com-
partment; then coat the battery posts
and cable ends with a light coat of
multi-purpose grease.
9. Connect the battery cables (positive
cable first); then install the battery
hold-down.
SPARK PLUG
The ATV comes equipped with a speci-
fied spark plug. See the Specifications
chart for the correct spark plug. A light
brown insulator indicates that the plug is
correct. A white or dark insulator indi-
cates that the engine may need to be ser-
viced. Consult an authorized Arctic Cat
ATV dealer if the plug insulator is not a
light brown color.
To help prevent cold weather fouling,
make sure to thoroughly warm up the
engine before operating. To maintain a
hot, strong spark, keep the plug free of
carbon.
Before removing the spark plug, be sure to
clean the area around the spark plug. If
you do not, dirt could enter engine when
removing or installing the spark plug.
Adjust the gap to 0.7-0.8 mm (0.028-
0.032 in.) for proper ignition. Use a
wire-type feeler gauge to check the gap.
ATV-0052
When installing the spark plug, be sure
to tighten it securely. A new spark plug
should be tightened 1/2 turn once the
washer contacts the cylinder head. A
used spark plug should be tightened 1/8
- 1/4 turn once the washer contacts the
cylinder head.
THROTTLE CABLE
ADJUSTMENT
To adjust the throttle cable free-play:
1. Loosen the jam nut from the throttle
cable adjuster.
2. Slide the rubber boot away and turn
the adjuster until the throttle lever
has the proper free-play of 3-6 mm
(1/8-1/4 in.).
ATV-0047
3. Tighten the knurled nut against the
throttle cable adjuster securely; then
slide the rubber boot over the adjuster.
CAUTION
Before installing the battery, make
sure the ignition switch is in the OFF
position.
CAUTION
Connecting cables in reverse (posi-
tive to negative and negative to pos-
itive) can cause serious damage to
the electrical system.
0.7-0.8 mm
(0.028-0.032 in.)