Arctic Cat 2015 M 6000, Руководство оператора

Страница: 17 / 64

13
Handlebar Height/Tilt
(M)
To adjust handlebar height, use the fol-
lowing procedure:
1. From each side of the steering post,
compress the locking tabs to unlock
the handlebar.
0747-618
2. With the tabs compressed, adjust the
handlebar up or down to the desired
position; then release the tabs to lock
the handlebar in place.

NOTE: When the desired height is
found, make sure that the lock collar
is seated in the grooves by lifting up
and pressing down on the handlebar.
To adjust handlebar tilt, use the following
procedure:
1. Loosen the four cap screws and tilt
the handlebar to the desired position.
0747-617
2. Tighten the four cap screws evenly
to 15 ft-lb.
Speedometer/
Tachometer Angle
(8000)
The speedometer/tachometer can be
adjusted to the operator’s desired posi-
tion. To adjust, use the following proce-
dure.
1. Loosen the lock nuts and cap screws
on each side of the speedometer/
tachometer bracket.
2. Adjust the speedometer/tachometer
to the desired angle; then tighten the
lock nuts securely.
Exhaust System
The exhaust system is designed to reduce
noise and to improve the total perfor-
mance of the engine. If any exhaust sys-
tem component is removed from the
engine and the engine is run, severe
engine damage will result.
Air-Intake Silencer
Used in conjunction with the fuel intake
system is a specially designed air-intake
silencer. The purpose of the silencer is to
quiet the intake of fresh air. Since the fuel
intake system is calibrated with the air-
intake silencer in place, the engine must
never be run with the silencer removed.
Performance will not be improved if the
air-intake silencer is removed. In con-
trast, severe engine damage will occur.
! WARNING
Tighten cap screws according to
specifications to prevent unexpected
“movement” of the handlebar during
operation over rough terrain. DO NOT
position the handlebar so steering
(maximum right/left turning capabili-
ties) or throttle and brake controls
are affected.
! WARNING
Tighten the cap screws according to
specifications to prevent unexpected
“movement” of the handlebar during
operation over rough terrain. DO NOT
position handlebar so steering (maxi-
mum right/left turning capabilities) or
throttle and brake controls are affected.
CAUTION
These snowmobiles are not designed
to be operated in dusty conditions.
Operating the snowmobile in dusty
conditions will result in severe
engine damage.