114
CC886
3. Using a flat-nosed punch, drive the bearing out of the
housing.
CC887
Installing Needle Bearing
1. Apply green Loctite #609 to the outside of a new
bearing; then place the new bearing into the housing.
CC888
2. Using a suitable driver, install the needle bearing into
the gear case housing making sure the bearing is
seated.
NOTE: Do not push the bearing too far into the
housing.
GC045A
3. Install the pinion shaft and secure with a new 48 mm
lock collar. Tighten to 125 ft-lb.
CC890
4. Place a punch on the edge of the lock collar in the oil
gallery area; then using a hammer, stake the lock col-
lar to ensure that the collar will remain securely
tightened.
CC891
5. Install the pinion housing.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
Содержание 2014 XC 450
Страница 1: ...450 ATV SERVICE MANUAL 2014 ...
Страница 3: ......
Страница 130: ...Printed in U S A Trademarks of Arctic Cat Inc Thief River Falls MN 56701 p n 2259 833 ...