50
GZ190C
NOTE: When the camshaft assembly is seated,
make sure the alignment pin in the camshaft aligns
with the smallest hole in the sprocket.
13. With the alignment pin installed in the camshaft,
loosely place the cam sprocket (with the recessed
side facing the camshaft lobes) onto the camshaft
and place it into position with the cam chain over the
sprocket.
CD463
MD1359
14. Place the C-ring into position in its groove in the cyl-
inder head.
FI615
NOTE: At this point, oil the camshaft bearings, cam
lobes, and the three seating journals on the cylinder
head.
NOTE: Note the position of the alignment marks on
the end of the camshaft. They must be parallel with
the cylinder head cover mating surface. If rotating the
camshaft and sprocket is necessary for alignment, do
not allow the crankshaft to rotate and be sure the
cam lobes end up in the down position.
15. When the camshaft assembly is seated, ensure the
following.
A. Piston still at top-dead-center.
B. Camshaft lobes directed down (toward the pis-
ton).
C. Camshaft alignment marks parallel to the valve
cover mating surface.
D. Recessed side of the sprocket directed toward the
cam lobes.
E. Camshaft alignment pin and sprocket alignment
hole (smallest) are aligned.
16. Place the tab washer onto the sprocket making sure it
covers the pin in the alignment hole.
CAUTION
If any of the above factors are not as stated, go back to
step 13 and carefully proceed.
Содержание 2014 XC 450
Страница 1: ...450 ATV SERVICE MANUAL 2014 ...
Страница 3: ......
Страница 130: ...Printed in U S A Trademarks of Arctic Cat Inc Thief River Falls MN 56701 p n 2259 833 ...