Arctic Cat 2013 Prowler XT, Руководство по обслуживанию

Страница: 191 / 233

6-18
CD754
10. Using CV Boot Clamp Tool, secure both outside
boot clamps.
CD024
ASSEMBLING AXLES
1. Install the inner boot with the small clamp making
sure the ends of the clamp are positioned correctly.

NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
CD754
2. Using the boot clamp tool, secure the small clamp of
the inner boot.
ATV-1048
3. Apply 80 grams (2/3 of contents) of grease from the
pack into the bearing housing.
4. Install the bearing onto the shaft making sure the
recess of the bearing is facing the housing.
CD022
5. Secure the bearing ring with the snap ring making sure
the sharp side of the snap ring faces away from the boot.
CD023
6. Making sure the marks made during disassembling
align, slide the housing over the bearing ring; then
completely seat the bearing ring into the housing and
install the snap ring.

NOTE: Pull the bearing ring out of the housing until
it contacts the snap ring; then slide the ring in half
way. This will purge air from the housing and ensure
the bearing is packed properly.
CAUTION
It is important the clamps are positioned correctly or
they may loosen when in motion.
CAUTION
The bearing ring must go onto the shaft with the side
without splines facing toward the small clamp of the
inner boot or severe damage will result.