39
KM373
7. Using a suitable holding fixture, tighten the drive
plate nut to 43 ft-lb.
Installing Left-Side
Components
A. Drive Pulley
B. Driven Pulley/Centrifugal Clutch
Assembly
C. V-Belt Cover
TR088
1. Install the movable drive face and drive pulley collar
on the crankshaft.
2. Open the faces of the driven pulley; then insert a
suitable wedge between the faces to hold them apart.
3. Place the V-belt around the pulley and push the belt
down between the pulley faces; then install the
driven pulley/centrifugal clutch assembly onto the
driveshaft. Loop the V-belt over the drive pulley col-
lar.
KM262
KM369
4. Place the fixed drive face into position on the crank-
shaft and engage the splines making sure the splines
extend beyond the pulley face hub.
KM263A
5. Install the starter ratchet on the crankshaft making
sure to engage the splines; then secure with the drive
pulley nut and tighten to 43 ft-lb.
KM365
AT THIS POINT
If the gear position switch was removed, install it into
the crankcase using a new O-ring. Tighten the cap
screw securely.
CAUTION
Make sure to orient the roll-pin with the longer end
directed to the rear. Failure to properly orient the switch
will result in failure of the neutral and reverse lights to
illuminate.