Arctic Cat 1000 Cruiser, Руководство по обслуживанию

Страница: 209 / 253

207

NOTE: If battery voltage is not shown in any test,
inspect the LIGHTS fuse, battery, main wiring har-
ness, connectors, or the left handlebar switch.
Taillight - Brakelight
The connector is the 3-prong one located under the rear
fender assembly.
VOLTAGE (Taillight)

NOTE: Perform this test on the main harness side of
the connector. Also, the ignition switch should be in
the LIGHTS position.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the white wire; then
connect the black tester lead to the black wire.
3. With the ignition key in the LIGHTS position, the
meter must show battery voltage.

NOTE: If the meter shows no voltage, inspect fuses,
wiring harness, connectors, and switches.
VOLTAGE (Brakelight)

NOTE: Perform this test on the main harness side of
the connector. Also, the ignition switch should be in
the ON position and the brake (either foot pedal or
hand lever) must be applied.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the red/blue wire; then
connect the black tester lead to the black wire.
3. With either brake applied, the meter must show bat-
tery voltage.

NOTE: If the meter shows no voltage, inspect fuses,
wiring harness, connectors, and switches.
Ignition Timing
The ignition timing cannot be adjusted; however, verifying
ignition timing can aid in troubleshooting other components.
To verify ignition timing, use the following procedure.
1. Attach the Timing Light to the spark plug high ten-
sion lead; then remove the timing inspection plug
from the left-side crankcase cover.
2. Using the Tachometer, start the engine and run at
1500 RPM; ignition timing should be 10° BTDC.
3. Install the timing inspection plug.
If ignition timing cannot be verified, the rotor may be
damaged, the key may be sheared, the trigger coil/CKP
sensor bracket may be bent or damaged, or the ECM may
be faulty.
Tilt Sensor
SUPPLY VOLTAGE
1. Disconnect the three-wire connector from the sensor;
then select DC Voltage on the multimeter and con-
nect the red tester lead to the orange wire (C) and the
black tester lead to the black wire (A).
CD706A
2. Turn the ignition switch to the ON position. The
multimeter should read battery voltage. If battery
voltage is not indicated, check the 30-amp main and
10-amp ignition fuses, wiring harness, or the ignition
switch.
3. Remove the red tester lead and connect to the
blue/brown wire (B). The multimeter should read
approximately 2.5 DC volts. If the specified voltage
is not indicated, check wire connections at the ECM
or substitute another ECM to verify the test.
CD706B
! WARNING
Incorrect installation of the tilt sensor could cause sud-
den loss of engine power which could result in loss of
vehicle control resulting in injury or death.
CAUTION
Do not drop the tilt sensor as shock can damage the
internal mechanism.