Arctic Cat 1000 Cruiser, Руководство по обслуживанию

Страница: 130 / 253

128
6. From the left side, install the case half 6 mm cap
screws; then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
7. From the right side, install the 6 mm cap screws;
then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
8. In a crisscross/case-to-case pattern, tighten the 8 mm
cap screws (from steps 4-5) until the halves are cor-
rectly joined; then tighten to 20 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
9. In a crisscross/case-to-case pattern, tighten the 6 mm
cap screws (from steps 6-7) to 8 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
Installing
Engine/Transmission
(550/700)

NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the ATV.
1. From the left side, place the engine/transmission into
the frame; then slide the engine rearward as far as
possible.
2. Slightly raise the rear of the engine and engage the
front drive coupler into the splines of the front drive
output yoke; then slide the engine forward as far as
possible.
CD818
3. Raise the rear of the engine and place a block
beneath it; then install the propeller shaft and output
flange into the rear drive coupler securing the boot
with new clamps.
CD821
4. Remove the block from beneath the engine; then
align the rear flanges and secure with four cap
screws (coated with red Loctite #271). Tighten to 20
ft-lb.
CD824
5. Install the engine mounting through-bolts and
mounting hardware; then tighten to 40 ft-lb.
CD809
6. Secure the exhaust pipe to the engine with two cap
screws making sure the mounting brackets engage
the frame grommets; then install the muffler and
tighten the nuts securing the exhaust pipe to 20 ft-lb.

AT THIS POINT
After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Com-
ponents.