11
H2-037A
3. Remove the drain plug from the bottom of the engine
and drain the oil into a drain pan.
733-441A
4. Using the adjustable Oil Filter Wrench and a suitable
wrench, remove the old oil filter.
NOTE: Clean up any excess oil after removing the
filter.
5. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new oil
filter. Tighten securely.
NOTE: Install a new O-ring each time the filter is
replaced.
6. Install the engine drain plug and tighten to 16 ft-lb.
Pour the specified amount of the recommended oil in
the filler hole. Install the oil level stick/filler plug.
7. Start the engine (while the ATV is outside on level
ground) and allow it to idle for a few minutes.
8. Turn the engine off and wait approximately one min-
ute.
9. Remove the oil level stick and wipe it with a clean
cloth.
10. Install the oil level stick and thread into the engine
case.
11. Remove the oil level stick; the oil level must be
within the operating range but not exceeding the
upper mark.
GZ461A
12. Inspect the area around the drain plug and oil filter
for leaks.
Liquid Cooling System
NOTE: Debris in front of the engine or packed
between the cooling fins of the radiator can reduce
cooling capability. Using a garden hose, wash the
radiator to remove any debris preventing air flow.
The cooling system capacity can be found in General
Information. The cooling system should be inspected
daily for leakage and damage. If leakage or damage is
detected, take the ATV to an authorized Arctic Cat ATV
dealer for service. Also, the coolant level should be
checked periodically.
NOTE: High engine RPM, low vehicle speed, or
heavy load can raise engine temperature. Decreasing
engine RPM, reducing load, and selecting an appro-
priate transmission gear can lower the temperature.
CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These oils
can adversely affect clutch operation. Also, not recom-
mended are racing, vegetable, non-detergent, and cas-
tor-based oils.
1000
CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is not above the upper mark.
CAUTION
Arctic Cat does not recommend using a pressure
washer to clean the radiator core. The pressure may
bend or flatten the fins causing restricted air flow, and
electrical components on the radiator could be dam-
aged. Use only a garden hose with spray nozzle at nor-
mal tap pressure.
CAUTION
Continued operation of the ATV with high engine tem-
perature may result in engine damage or premature
wear.
Содержание 1000 Cruiser
Страница 1: ...500 550 700 1000 MUD PRO TRV ATV SERVICE MANUAL 2014...
Страница 252: ...250 NOTES...
Страница 253: ...Printed in U S A Trademarks of Arctic Cat Inc Thief River Falls MN 56701 p n 2259 841...