Arcon IRONHORSE 300S, Руководство по эксплуатации

Страница: 9 / 25

9
2. Introduction and Installation
•
WARNING!
•
Only qualified personnel should perform this installation.
•
Turn the input power off at the disconnect switch or fuse box before working on
The Ironhorse.
•
Do not touch electrically hot parts.
This section provides detailed instructions for the proper installation of The Ironhorse . It is
recommended that these instructions be followed carefully to allow for the best possible
operating environment.
2.1 Unpacking and selecting a Location
a. Immediately upon receipt of the welder, inspect the shipping box for any damage
and notify the carrier of such damage before accepting delivery. Then inspect the
Ironhorse for damage, which may have occurred in transit. After removing the
components from the shipping container(s), check the container for any loose
parts. Remove all packing materials.
b. Check air passages of power source for any packing materials that may obstruct
airflow through the welder.
c. If the equipment is not being installed immediately, store it in a clean, dry,
well-ventilated area until installation.
a. The location of the power source should be carefully selected to ensure
satisfactory and dependable service. Choose a location relatively close to
a properly fused source of electrical power.
b. It is important that the machine be located in an open area where air can
circulate freely at front and rear openings. If space is at a premium, leave
at least 1 foot (300 mm) of clearance between the rear of the power source
and wall or other obstruction.