Arcon IRONHORSE 300S, Руководство по эксплуатации

Страница: 5 / 25

5
Ironhorse Setup Checklist
NEVER WELD ON THE LIVE THIRD RAIL!
These are basic instructions for installing cables and supplying power to The Ironhorse welding
power source. The individual connecting cables for welding should be certified (by the
employer) and be familiar with the fundamentals of welding and electricity.
All precautionary measures must be taken to provide maximum
protection against electrical shock. Work cables must always make a
good electrical connection with the metal being welded. Connection
should be as close as possible to the area being welded.
Operators must always insulate themselves from the work and ground
using dry insulation. Wear dry gloves to insulate hands
.
Make certain
the insulation is large enough to cover the entire area of physical
contact with the work-pieces and the ground.
Basic Setup Procedure:
1. Be sure the power breaker on back of welder is OFF.
2. Be sure the work cable makes a good electrical connection with
the metal being welded. The connection should be as close as
possible to the area being welded.
3. Hook up welding cables to welder.
4. Attach ground (GND) cable to the work to be welded.
5. Attach the Power (GND) cable to the (GND) rail.
Attach the Power +DC cable to the +DC power rail.
CAUTION – this lead is connected to HIGH VOLTAGE!
6. Switch the breaker switch on the back of the welder ON .
7. Never leave the energized power source unattended.
8. Turn the breaker off before disconnecting the input power
conductors and welding cables, and BEFORE moving the welding
power source to a new location.
Remember - the electrode and work (or ground) circuits are
electrically “hot” when the w elder is on. Do not touch these energized
parts with bare skin or wet clothing. Dry, hole-free gloves to insulate
hands should ALWAYS be worn.