arcelik Beko B13, Руководство по обслуживанию

Страница: 63 / 111

B13 B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
63
Yes
Replace control card.
No
Open the rear cover of the machine.
Measure heater resistance by removing at
least one of the heater terminals; is the
resistance 25 Ohms? (Picture E2-4)
Replace the heater
Is there E2 error?
Check to see if there is any short
circuit between the first pins of
both connectors.
(Picture E2-3)
No
Yes
Check water level sensor.
Measure the frequency
between pins 1 and 3 while
the machine is empty and
energized. It should be
around 25560 Hertz.
(Picture 2-5)
Does the heater
operate although there is
no water?
Yes
Remove the panel for a
comfortable measuring.
Remove KN5 (Picture E2-1)
Heater socket and KN8
(Picture E2-2) Tacho socket.
Yes
You may start the washing
program.
No
Important Note:
The washing machine makes cold washing
and ends the program before the heater is
activated in NTC open circuit / short circuit
and Heater open circuit conditions, i.e. if
there is E1, E2 or E3 error.
PICTURE E2-4: One of the cables on the
heater is removed (left) and heater resistance
is measured.
* Heater open
circuit error
E2
0
0
0
1
0
*Does not heat
water.
*Machine boiled
the water once,
but now it does
not heat at all.
PICTURE E2-1: Heater socket on
the KN5 card is removed. PICTURE E2-2: KN8 tacho socket is removed.
PICTURE E2-5: Water level sensor is being
checked
PICTURE E2-3: Short circuit check is being
made between KN8-1 pin and KN5-1 pin.