arcelik Beko B13, Руководство по обслуживанию

Страница: 56 / 111

B13 B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
56
power which is consumed by WM and check heater. ii) On a machine with "Main Wash
Flow Meter":
"Main_Wash_Flow_Meter" will be checked to see if it is higher than "50" or not.
If it is higher than 50, then Flow_Meter is operating correctly; HEATER will turn on
automatically and a 52rpm right turn will be applied.(In models with flow meter, there is
motor movement) If it is below 50, then the Flow_Meter is faulty and therefore the heater
will not be "DRIVEN" and proceeded to the next step of the service mode ("step_12").
In this way Flow_Meter error will be identified.
Meanwhile, "11", which is the service mode step number is displayed on screen of 7S
Models;
In Models with LED, of the "Programme Tracking LEDs" above the "Start/Pause" button
the 1st, 2nd and 4th LEDs from the bottom will be turned on (weight of orders from
bottom to top are 20=1, 21=2, 22= 4, 23 = 8, 24 = 16);
Next test step is taken by pressing the "Start/Standby" button.
12)
“HEATER” which is opened for test in the previous step is shut. Also, the motor
movement which is started in the previous step is finalized and all valves are shut.
“PUMP” which is the main test of this step is opened and water inside the WM is drained
below "Safety_Level". When the water level comes below “Security_Level”, pump is shut
off.
At the beginning of the drain process, MAIN_WASH and HOT_WATER valves will be
turned on for 5 seconds (Rev01_22072011)
Meanwhile, "12", which is the service mode step number is displayed on screen of 7S
Models;
In Models with LED, of the "Programme Tracking LEDs" above the "Start/Pause" button
the 3rd and 4th LEDs from the bottom will be turned on (weight of orders from bottom to
top are 20=1, 21=2, 22= 4, 23 = 8, 24 = 16);
"At the spinning stage, if no error, "turn at max/2 speed" "rule is modified as "turn at max
speed"
.
The 52 RPM right turn movement at the heater stage is removed.
Since this step is the last stage of the service test, if the “Start/Pause” button is pressed
for one more time, this will return to step 1.