DXE Crossover
1.
Balanced Input
:
This balanced line connector should be connected to the DXE
Equalizer, Be careful to plug it into the right spot. This cable will plug into the remote
display port but this is a bad thing. Don’t try it.
2.
Power Out
:
This powers the EQ Section. If you are not getting any lights on your EQ
check this connection.
3.
Remote Display
:
This is a 10-pin flat wire cable. Do not mistake it for the 8 pin
Balanced Line cable. It won’t work.
4.
Power Connection
:
Ground, Remote turn and 12 volt positive are connected at this
plug. Do your self a favor. Wire the plug outside the car. This will save you a lot of trouble
if the crossover is located in a hard to reach area.
5.
Fuse
:
You should never replace this fuse with anything other then the recommended 3
amp fuse.
6.
High Pass Crossover Output
:
This is a selectable 12dB/24dB Stereo crossover
adjustable from 16Hz – 7100Hz
7.
Crossover 3
:
X3 is a 12dB stereo crossover selectable as High Pass, Low Pass,
Band Pass or Full Range, Fully adjustable to 7100Hz.
8.
Crossover 2
:
X3 is a 12dB stereo crossover selectable as High Pass, Low Pass,
Band Pass or Full Range, Fully adjustable to 4900Hz.
9.
Sub Crossover:
The Subwoofer crossover is selectable 12dB/24dB/24dB. Output is
in Mono.
10.
Center Channel Output
:
The center channel is an unprocessed mono (L+R)
output. It has an adjustable level.
7
