Back Panel
1.
Inputs:
The DXE has two RCA inputs that need to get their audio signals from the
source units (CD Player and Video system). If your source unit has multiple outputs (like
a front, rear, and/or subwoofer) you should only connect the front or rear outputs to your
DXE.
2.
Input Levels:
These switches allow you to maximize the signal level from your source
unit that goes into your DXE to achieve maximum signal to noise. Keep in mind, that
despite what the literature says, most aftermarket source units produce a relatively low
voltage signal when it comes to playing music at normal levels.
3.
Balanced Outputs:
This balanced line connector should be connected to the DXE
crossover module, be careful to plug it into the right spot.
4.
Power Connection:
This connector looks like a Telephone cable. Well it is, but this
removes the power supply from the EQ and moves it into the crossover were there is
room to shield it properly. As a result you get much lower noise and no chance of ground
loop.
INPUT A
GAIN
OUTPUT
POWER
12db
0db 6db
12db
0db 6db
L
R
R
L
INPUT B
INPUT A
INPUT B
5
