ARANA FOGATTI FS06B1, Инструкция по установке и эксплуатации

Страница: 40 / 68

EN
40
04
When the water heater is installed, it should be reliably grounded.
Clean any dirt in the supply pipes before they are connected to the heater.
You must install a filter that is easily accessible for cleaning in the water supply line/s
after the pump and before the heater. Failure to do so voids warranty.
Valvess should be installed in gas pipe, inlet pipe and outlet pipe for easy
maintenance.
Check the gas leakage and water leakage after installation, make sure there is no any
gas and water leakage.
The minimum distance from the exhaust outlet to the flammable surface should be
>500mm.
The gas pressure range for the normal operation of the water heater is that the
maximum inlet pressure cannot exceed 3.3 kPa (13'' w.c.) and the minimum pressure
cannot be lower than 1.99 kPa (8'' w.c.). Out of range will not work normally.
If a relief valve discharges periodically, this may be due to thermal expansion
in a closed water supply system. Contact the water supplier or local plumbing
inspector on how to correct this situation. Do not plug the relief valve.
Danger
>500mm