ARANA FOGATTI FS06B1, Инструкция по установке и эксплуатации

Страница: 47 / 68

Make A Difference 卓 / 尔 / 不 / 凡
EN
47
Correctly install the SAE 3/8′′ liquefied gas pipe on the back of the water heater.
Correctly connect the volt power cable to the power cable on the back of the water
heater.
Red is positive, black is negative; connect the line controller with the two blue lines
on the back of the water heater, it is not necessary to divide the positive and negative
poles; pay attention to the water pipe, trachea, and wires on the back of the water
heater to leave enough length to pull the water heater from the mounting hole. See
FIG.10.
Installation of wiring and wired controller must be installed by professional person,
service company or gas water heater suppliers.
The paste should be flat and connected seamlessly. (Be careful not to be too thick)
Then press this product into the opened hole.
The water heater flange cover is glued with 18mm wide single-sided adhesive
anti-flaming EVA.
18mm anti-flaming EVA
10
DC 12V
Please use DC 12V RV battery
Gas inlet SAE 3/8"
Water outlet G 1/2''
Water inlet G 1/2''
This water heater is designed for RV users. The working voltage is DC 12V RV
battery and the gas source is propane.
Excessive force will damage the water heater's cold water and hot water
connections. When installing the gas joint, tighten the joint with two wrenches to
avoid damaging the water heater joint.
DANGER!