ARANA FOGATTI FS06B1, Инструкция по установке и эксплуатации

Страница: 51 / 68

Make A Difference 卓 / 尔 / 不 / 凡
EN
51
5.0 Operation instructions
Note: DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
Note: DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THIS APPLIANCE.
Note: DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
Note: DO NOT MODIFY THIS APPLIANCE.
Before installing the water heater, a water mixing valve must be installed. At the
rated setting, the equipment to provide water is not more than 51℃ . When water
flow is small or inlet water temperature is high, water heater will heat the water to
the likely above 51℃ . At this moment, please open the mixing valve to provide
you with a comfortable shower temperature.
Prior to first operation, please remove any packing protection, like plastic film,
plastic bag, plastic sealing tapeor any packing material can block the outlet of
water heater.
Confirm that the power switch in the water heater is turned on; See FIG.14.
After confirming the power is on, press the wire controller key " ";
Turn on the water inlet valve and gas valve at the gas cylinder;
Turn on the water outlet valve (hot water tap), the water heater is ignited, and hot
water flows out.
The installer must provide an installation certificate that the water heater is installed
correctly before the initial use, carefully check that the connections are properly
connected and leak free. After confirming it, please follow the below steps:
DANGER!
5.1 The steps for starting the unit