General and maintenance information
-
The water supply to the appliance must be switched off when not in use
-
Pre-filters, post-mineralization and post-activated carbon filters are replaced once a year and the osmosis
membrane once every two years. If the water quality is abnormal, it is possible that the filters will clog
faster, resulting in a slower water output. In this case, the filters must be replaced earlier.
-
The device produces clean water in the intermediate water tank at a rate of about 3 dl per minute when
the water supply network feed pressure is about 3.5 bar. However, if the hardness of the water or, for
example, the salinity is elevated, it is possible that the yield of the device will slow down or even stop. In
this case, increasing the supply pressure to the network can help.
-
It is advisable to monitor the quality of the purified water regularly to ensure that the appliance is working
properly.
-
If the appliance is not used for more than 2 weeks, it is recommended to empty the fresh water tank twice
and refill it before use.
-
The appliance must not be allowed to freeze.
-
If the device is taken to a warm place from the cottage during the winter season, for example, drain the
water from the appliance, disconnect the hoses and plug the connectors, using the supplied color-coded
plugs. Close the valve of the fresh water tank. The hoses and the tap can be left in place.
-
When re-installing in the spring, the pre-filters are replaced with new ones and the commissioning steps
are performed and the water tank is flushed twice.
-
If the device is used to make clean water from natural water, e.g. from a lake, it is recommended to do
sufficient pre-filtration already with a domestic water pump, using at least a fine filter of 1 µm or 5 µm.
-
If the device only produces flushing or reject water, but not clean water, the supply pressure of the network
is probably too low. In this case, it is advisable to check that the lower pressure limit of the pump in
particular has been set.
Replacement filter:
-
Osmotic membrane, product code: AQ060
-
Prefilters, with product codes: AQMF5-M and AQCB-M
-
Post-mineralization, with product code: AQ006-PM
-
Post-activated carbon, with product code: AQ006-PC
You can find replacement filters in our online store via menus or by using the quick search field with product
codes.